Point Source Audio CO-3 Condenser Earworn Microphone 4 Pin Mini Telex Connector Beige

The Point Source Audio CO - 3 - TX - BE Condenser Earworn Microphone in beige comes with a 4 - pin mini Telex connector. It's an entry - level earworn mic ideal for speech reinforcement in church liturgy, lectures, and other hands - free applications that need high - quality vocal pickup. With an omnidirectional polar pattern, it captures sound in a full 360 - degree range, blending voice and ambience naturally. Its design cuts down popping sounds and voice overloads in close - mic use, and its placement near the mouth reduces wind and clothing noise. It offers clear sound in close - talk operation and excellent gain before feedback, perfect for applications where high speech intelligibility is required. This single over - ear model for basic speech includes a microphone and a body clip. Key features: It can only be worn on the left ear, handles up to 116 dB SPL, has an ultra - low profile, is an affordable earworn solution, provides increased gain before feedback, and has a stationary left - ear boom that needs no adjustments. Technical specs: Color is beige. Connector is a 4 - pin mini for Telex. Element is a Back Electret Condenser. Pattern is omnidirectional. Frequency range is 50 Hz - 16kHz. Sensitivity is - 44 dB 1V/Pa (Nominal Sensitivity +/- 3dB at 1kHz). Maximum SPL is 116dB. Output Impedance is 1,500 ohm ± 30% (at 1kHz). Operating Voltage is 1.5V - 10VDC. Cable Length is 3 ft 11 in + connector. Net Weight is.28 oz. Boom is fixed and not bendable. It comes with a storage box.

Using the Point Source Audio CO - 3 condenser earworn microphone is easy. First, put the microphone on your left ear as it's designed to be worn only on the left. The stationary boom doesn't need any adjustment, so you can just place it near your mouth. Connect the 4 - pin mini Telex connector to your device. You're ready to start speaking, whether it's for a church service or a lecture. When it comes to power, make sure the operating voltage of your device is between 1.5V and 10VDC. As for maintenance, keep the microphone in the included storage box when not in use. Avoid exposing it to extreme temperatures or moisture. Also, be careful not to subject it to very high sound pressure levels above 116 dB SPL, as this could damage the microphone. If you notice any issues, check the connections first and make sure the cable isn't damaged.